Conceptronic 150N Bedienungsanleitung PDF herunterladen (Seite 31)

ENGLISH

3. Renew the IP address of your computer with the following commands:

- ‗IPCONFIG /RELEASE‘ : this will release the incorrect IP address

- ‗IPCONFIG /RENEW‘ : this will renew the IP address

If above steps do not solve the IP address issue, you can reset the device to the factory default settings

with the reset button on the back of the device.

Press and hold the reset button until the power LED starts to flash (about 10 seconds). This will reboot the

router and load the factory default settings into the router. When the power LED burns steady again,

repeat step B to renew the IP address.

Note: If the problem remains, check if all cables are connected in the correct way. The WAN port

should be connected to the modem and the LAN port to the computer. Connecting them in the

wrong way will also result in an incorrect IP address.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 225 226

Keine Kommentare

Conceptronic 150N Bedienungsanleitung Seite 31